GT07 Monochrome X-Ray Battery Testing Mold – PEEK 20mm, 1–6mm, 500MPa | Xnergy

Name: GT07 Monochrome X-Ray Battery Testing Mold

Mold Type: Battery Test Mold for Monochrome X-Ray Measurements

Product Code: XN-BM-GT07

Description:

The GT07 is a battery test mold designed for monochrome X-ray measurements. The mold features a sleeve diameter of 20 mm, an assembly height of 60 mm, and an inner diameter range of 1–6 mm. The GT07 is built with stainless steel and PEEK (polyether ether ketone). Can be customized and modified as required.

Application:

The GT07 is designed for laboratory monochrome X-ray testing in battery research. The compact cylindrical body geometry supports X-ray measurements of battery samples.

Specifications:

Values measured by Xnergy. Typical values for reference; not guaranteed unless otherwise specified.

Characteristics:

Compact cylindrical body

The GT07 features a compact cylindrical body geometry (20 mm sleeve diameter, 60 mm assembly height) suitable for laboratory benchtop deployment.

Fine inner diameter range (1–6 mm)

The GT07 supports an inner diameter range of 1 mm to 6 mm.

PEEK insulating sleeve

The GT07 uses a PEEK (polyether ether ketone) insulating sleeve. PEEK is a high-performance thermoplastic with high dielectric strength and chemical stability against a wide range of chemicals.

Stainless steel frame

The GT07 frame is constructed from stainless steel.

Customization available on request

The GT07 can be customized and modified as required. Contact Xnergy for configuration options that match your specific research requirements.

Recommended Operating Procedure:

1. Clean all mold components with isopropyl alcohol or other suitable cleaning solvent before each use; dry thoroughly. 2. Apply a thin layer of vacuum grease or anti-seize compound between contacting surfaces and the PEEK sleeve to reduce friction. 3. Assemble the cell components in their designated positions. 4. Tighten the locking screws on the frame to maintain assembly integrity during transfer to the X-ray system. 5. Mount the assembled mold onto the X-ray sample stage. 6. Perform X-ray measurements together with electrochemical measurements as required. 7. After testing, disassemble and clean all components before storage.

Packaging & Storage:

The GT07 ships with all components, including the stainless steel frame, PEEK insulating sleeve, sealing components, and assembly hardware. Store in a dry environment at room temperature, protected from dust and moisture. After each use, clean components with isopropyl alcohol and store in a clean, dry environment.

Safety:

For research and industrial laboratory use only. Always wear appropriate PPE (safety glasses, chemical-resistant gloves, lab coat) when handling reactive materials and electrolytes. When working with reactive materials, follow standard laboratory safety protocols, including glovebox-based assembly when required. Follow standard X-ray safety protocols (radiation badges, interlocked shielding, beam containment) at all times. Refer to the included user manual for complete safety and operating instructions.

Note: Specifications listed above are typical and for reference only. Actual performance depends on the specific X-ray measurement type, sample chemistry, and experimental conditions — consult published literature for guidance on specific in-situ X-ray measurement protocols. For researchers exploring complete in-situ characterization workflows, see also Xnergy’s related products: GT06 In-Situ Raman Battery Test Cell, GT16 End-Face Raman Testing Mold, GT17 Voltage-Stabilized Single-Stud Raman Testing Die, GT08 Microscopic Battery Test Mold, YT09 In-Situ Dendrite Observation Mold, GT01 Standard Solid-State Battery Mold, GT02 Standard Solid-State Battery Mold, GT03 High-Pressure Solid-State Battery Mold, GT04 Three-Electrode Solid-State Battery Mold, and GT05 Square Solid-State Battery Test Cell. Browse the full Battery Mold category for all configurations.